Pre -picking data

[quickvfr]

I have a report that filters out data based on a couple of variables but then, based on that information I need to go back and check if there are multiple occurances of a piece of this data in what was already filtered out. I have set up accumulators and they work perfectly if the first filter is turned of since the data has not been picked through yet. The filter, by itself, works as intended as well. Is there a way to make these two things work seperately? Basically, the accumulator needs to run on un-picked data and then the data left be filtered by the variables. I have tried every iteration of processed/pre-processed accumulation but is only counting filtered data.____Thanks!__Pat Quick__Planogramming Solutions, Inc.__Jackonville, FL

[quickvfr]

I figured this out... Thanks...

[Top_Dev_User]

Glad you worked it out. Could you post the solution so that the rest of us do not have to "re-invent the wheel" when we have the same or a similar problem???____-ODW-__