Page 1 of 1
Email Burst
Posted: Wed Jul 11, 2001 11:08 am
by MIke_Csom_(Guest)
When I run the email bursting option, I get "No recipient specified, this report will not be sent!"____I look at my email field and the data is valid. What does R&R think a valid recipient is?____Any help is much appreciated.
=> RE: Email Burst
Posted: Wed Jul 11, 2001 11:11 am
by kfleming
Does your email field come from your master file?__Do you have the field placed on your layout and does it display valid data when you preview?____Kathleen__R&R Support
==> RE: Email Burst
Posted: Wed Jul 11, 2001 11:25 am
by MIke_Csom_(Guest)
My email field comes from a related table.____It is on my layout and it displays correctly on the preview.____My concern is that R&R does some validation to make sure it is a valid email address and the logic doesn^t coincide with our email addresses.____Our email addresses are username@companyname and I think R&R is expecting username@companyname.com
===> RE: Email Burst
Posted: Wed Jul 11, 2001 2:26 pm
by kfleming
We do absolutely no validation.__The only reason that you should see the no recipient error is when the email field is blank.__Try a query for non-blank email addresses and see if that helps.__Also-are you using a FlexLink index in the relation?____Kathleen__R&R Support
====> RE: Email Burst
Posted: Fri Jul 13, 2001 10:47 am
by MIke_Csom_(Guest)
Can you use a calculated field as your send to field?
=====> RE: Email Burst
Posted: Fri Jul 13, 2001 2:00 pm
by kfleming
You will be able to once the 9.0.008 update gets posted to the web site next week.__Prior V9.x releases did not allow this.____Kathleen__R&R Support__