Page 1 of 1
Flexlink in Runtime
Posted: Thu May 31, 2007 10:59 am
by Tom_(Guest)
In runtime I get the message ^Program canceled^. Looks like the report never gets started. In designer it runs just fine. Having problems with several reports & all have flexlinks. I was able to change the flexlink to an actual index in one report & it ran ok. Is there somewhere else I can look for a more detailed error message or do you have any ideas? Running version 12.1.0.1. Thanks
=> RE: Flexlink in Runtime
Posted: Thu May 31, 2007 4:18 pm
by Tom_(Guest)
Message is "Report Canceled" instead of ^Program Canceled"
==> RE: Flexlink in Runtime
Posted: Fri Jun 01, 2007 6:58 am
by kfleming
We have seen this and are investigating the problem.____Kathleen__R&R Support
===> RE: Flexlink in Runtime
Posted: Tue Jun 05, 2007 3:56 pm
by Tom_(Guest)
Any resolution yet? We are running each report in designer rather than out normal runtime batch. Thanks.
====> RE: Flexlink in Runtime
Posted: Mon Jun 11, 2007 4:10 am
by kfleming
Do you have the file FASTIDX.EXE in the same folder as RRWRUN.EXE?__You can see this error if this file is not available.____Kathleen__R&R Support
=====> RE: Flexlink in Runtime
Posted: Tue Jun 12, 2007 11:14 pm
by Tom_(Guest)
With Fastidx.exe in same directory as rrwrun then we get the error ^Cannot locate the Microsoft Visual FoxPro Support Library^.
======> RE: Flexlink in Runtime
Posted: Wed Jun 13, 2007 10:01 pm
by kfleming
You need the Visual Foxpro runtime files to use fastidx.exe.____These are;__VFP7R.dll__VFP7RENU.DLL__VFP7RUN.EXE__VFP7T.DLL______Kathleen__R&R Support