Page 1 of 1
Lastpage()
Posted: Tue Sep 02, 2003 12:26 pm
by Charles_Morris_(Guest)
The lastpage() function no longer works in my reports. I have a calculated field using lastpage() function to print Page pageno() of lastpage(). Whenever I run a report using the lastpage function, I get the error Calculated field <fieldname> must be edited.____This now occurs on my existing reports that had previously run with no problem. I take out the lastpage() function and everything is fine.__Using just the lastpage() function by itself, same error. ONLY when the lastpage function is not used will it work.____I am using Windows 2000 Pro and R&R Ver. 10 with upgrades and patches in place. Using with Xbase databases.____The reports work OK inside of R&R, but not when called from my programs. Used to work OK.
=> RE: Lastpage()
Posted: Wed Sep 03, 2003 8:09 am
by kfleming
Make sure that you runtime executable is not an earlier R&R version that did not support the lastpage() function.____Kathleen__R&R Support
==> RE: Lastpage()
Posted: Wed Sep 03, 2003 8:47 am
by Charles_Morris_(Guest)
Version is 10.0.12.0 It is the only version I have installed on the machine.
===> RE: Lastpage()
Posted: Fri Sep 05, 2003 12:14 pm
by kfleming
Do you get the error in the Designer as well as in runtime or only in runtime? If the latter, be absolutely sure that there is only one RRWRUN.EXE out there.____Kathleen__R&R Support
====> RE: Lastpage()
Posted: Sun Sep 07, 2003 12:04 pm
by Charles_Morris_(Guest)
Kathleen;____Your are sharp!____There was an older version of RRWRUN.EXE in a folder that should have been removed during the uninstall. Works OK now.____Thank You.