Page 1 of 1
Line Count
Posted: Mon Sep 29, 2003 4:04 pm
by Thomas_Freitas_(Guest)
I was wondering if there is a way to reset a line count to zero when a new page occurs.____I have a totals calculation that states to count all the initial:____COUNT(init,est_inv(),automatic,running)____est_inv is: iif(at("QUOTE",dbf())<>0,"Estimated Repair",inv_number)____The report puts a line number next to each line if the file being used is the QUOTE.DBF file. If not, then no line number is printed on the report.______Thanks____Tom Freitas
=> RE: Line Count
Posted: Mon Sep 29, 2003 8:26 pm
by kfleming
Check if page is an available reset level for this total.____Kathleen__R&R Support
==> RE: Line Count
Posted: Tue Sep 30, 2003 2:48 pm
by Thomas_Freitas_(Guest)
The line count is in the main body of the report and therefore would not have a reset level.____I have checked in the totals in options and nothing there that I can use. ____I have also checked the properties on the band line and there is nothing there either.____If there is nothing available, then I assume that this might be in a future upgrade?______Thanks__
===> RE: Line Count
Posted: Tue Sep 30, 2003 3:04 pm
by Thomas_Freitas_(Guest)
Never mind, there was a reset____Thanks