Page 1 of 1
OCX Display Destination
Posted: Fri Apr 20, 2001 4:08 pm
by tsnyder9185
When using the Viewer Control, setting teh .Destination to Display (1) seems not to work. The report goes to the printer.____Is there a magic formula to make this feature work as expected?____Setting the .Destination to Prompt and subsequently selecting Screen, works OK. Similarly the other destinations seem to work OK i.e. to printer and to file.__
=> RE: OCX Display Destination
Posted: Mon Apr 23, 2001 10:47 am
by kfleming
Display should work just like it does for printer or file.__No known problems in this area.____Kathleen__R&R Support__
==> RE: OCX Display Destination
Posted: Mon Apr 23, 2001 1:12 pm
by tsnyder9185
Setting .Destination to 1 sends the report to the printer, not the screen. The report is in a .RP1 library. Setting .Destination to 6, Prompt, then selecting , Screen, sendss the report to the screen.____
===> RE: OCX Display Destination
Posted: Tue Apr 24, 2001 5:18 pm
by kfleming
Arghh!____I am seeing the same problem on my test machine.____Stay tuned for further developments...____Kathleen__R&R Support
====> RE: OCX Display Destination
Posted: Wed Apr 25, 2001 10:18 am
by kfleming
This is not a new problem. I went back to Version 8.0a (the last Wall Data build) and it was there as well.____Reports in libraries and destination=1 do not work.____Kathleen