Page 1 of 1
Parameter problem in R&R9 SQL
Posted: Wed Nov 06, 2002 8:57 am
by Morris_Evans_(Guest)
Set up a character Parameter in R&R9, have a filter testing a field against the Parameter, preview the report... The report comes out with the default value of the Parameter instead of the supplied value.__Yet if the Parameter is displayed on the report, the supplied value is shown. (with the default value used in the filter.)____Hope that makes sense to someone !____Is there a workaround / Fix ?____Morris.______
=> RE: Parameter problem in R&R9 SQL
Posted: Wed Nov 06, 2002 3:55 pm
by kfleming
Are you using 9.0.009?____Kathleen__R&R Support
==> RE: Parameter problem in R&R9 SQL
Posted: Thu Nov 07, 2002 9:55 am
by Morris_Evans_(Guest)
Yes, already fully patched to .009____Where to next ?____Morris.
=> RE: Parameter problem in R&R9 SQL
Posted: Fri Dec 06, 2002 9:28 pm
by Neeraj_Kamat_(Guest)
Create a calculated field as:____Calculated_field = RR(ParameteRR_field)____Use the calculated field in the filter.____Then the report will bring back data with the new value input while executing the report.