Page 1 of 1
Printer setups
Posted: Sun Aug 29, 2004 12:32 pm
by Wolfgang
Hallo,__I work with Version 9.0.009. When I save a report, some printer data´s will saved with the file. Is it possible to change these?__Thanks__Wolfgang
=> RE: Printer setups
Posted: Mon Aug 30, 2004 7:39 am
by kfleming
The printer name and location are saved with the report.__In V10 (but not in V9) you can add an INI setting to tell R&R to ignore the saved printer and use an alternate one instead.____Kathleen__R&R Support
==> RE: Printer setups
Posted: Thu Nov 04, 2004 11:03 am
by Nick
We default our reports to the default Windows Printer. This sounds similar - that you are hardcoding a printer.____Is there any way within the runtime to enable the user to select a printer, instead of always defaulting to the Windows Default or using and ini file?
===> RE: Printer setups
Posted: Fri Nov 05, 2004 1:34 pm
by kfleming
You would have to use a control table and set RI_WPTR=? to default to always prompting.____Kathleen__R&R Support
====> RE: Printer setups
Posted: Wed Dec 08, 2004 11:08 am
by Servicebfn
When I set ri_printer to "?" and ri_wptr to "?", I^m successfully prompted twice, and if I choose Printer for Report Destination and then choose the network printer of my choice, I consistently get the error message: "Cannot match printer or port in control file."
=====> RE: Printer setups
Posted: Wed Dec 08, 2004 10:50 pm
by kfleming
Is there anything set in the RI_PORT field?____Kathleen__R&R Support