Page 1 of 1
Printer values in R&R v9 on NT
Posted: Tue Nov 12, 2002 10:38 am
by Bryan_Beaton_(Guest)
Hello,____I have seen a couple of articules mentioning the RI_WPTR value that can be set to choose which printer R&R uses (other than the Windows default). Where can I locate this parameter? Is this the only entry I will need to make and what is the correct format?____Thanks.
=> RE: Printer values in R&R v9 on NT
Posted: Tue Nov 12, 2002 12:57 pm
by kfleming
You would use this field only if you are running reports via runtime.__If you are using the Report Designer, this would not apply.____Kathleen__R&R Support
==> RE: Printer values in R&R v9 on NT
Posted: Wed Nov 13, 2002 9:09 am
by bryan
Report Designer is being used. I have been asked if I can set-up R&R so that a dedicated printer is always shown - this would be a different printer to the default windows printer. It is hoped that settign this up will help resolve a print alignment problem that the user has been experiencing. ____I would appreciate if you could advise how this could be done.____Thanks, Bryan