Page 1 of 1
R&R with Novell6
Posted: Wed Sep 03, 2003 3:22 pm
by Roger_(Guest)
We copied all the file from a Novell 4.10 server to a Novell 6 cluster all paths keep the same. R&R runtime will produce report, but when you try to get out of it it does not release the license and an error I keep getting this message when I close R&R message comes up.__"rrw.exe has generated errors and will be closed by windows.You will need to restart the program."__ ____It also does not clear out of memory. If you are shutting down windows will prompt for end task and there is nothing open.__Thanks, Roger@harcofittings.com
=> RE: R&R with Novell6
Posted: Thu Sep 04, 2003 7:19 am
by kfleming
Which version of R&R are you using?____Kathleen__R&R Support
==> RE: R&R with Novell6
Posted: Thu Sep 04, 2003 4:03 pm
by Michael_Hyland_(Guest)
We upgraded from 9 to 10(build 10.0.012) this past Feb. We simply copied the entire R&R program file folder to an identical tree on the new server. We did not re-install R&R on the clients. We have also implemented Novell^s iPrint printing utility on every workstation. The new Netware 6.0 server uses straight IP protocol, our old 4.10 server used IP/IPX w/Novell Queue printing.____Another problem we are experiencing is opening a report that was saved with a Novell Queue based printer assignment. When we try to change the printer assignement while in the designer, then save, it crashes every time and blows you right back to the desktop.____Michael Hyland - Harrington Corp.____>Which version of R&R are you using? __>__>Kathleen __>R&R Support __
==> RE: R&R with Novell6
Posted: Mon Sep 08, 2003 1:41 pm
by Michael_H._(Guest)
We upgraded from 9 to 10(build 10.0.012) this past Feb. We simply copied the entire R&R program file folder to an identical tree on the new server. We did not re-install R&R on the clients. We have also implemented Novell^s iPrint printing utility on every workstation. The new Netware 6.0 server uses straight IP protocol, our old 4.10 server used IP/IPX w/Novell Queue printing.____Another problem we are experiencing is opening a report that was saved with a Novell Queue based printer assignment. When we try to change the printer assignement while in the designer, then save, it crashes every time and blows you right back to the desktop.____Michael Hyland - Harrington Corp.____>Which version of R&R are you using? __>__>Kathleen __>R&R Support
===> RE: R&R with Novell6
Posted: Mon Sep 15, 2003 3:20 pm
by kfleming
I would try re-installing R&R to see if that helps.__You can also try adding a line to the Defaults section of your RRW.INI/RSW.INI that says:__Printer=<printername> __where <printername> is either the word Default or the actual name of the printer you would like to use by default for any reports that you create or open.____Kathleen__R&R Support