Page 1 of 1
R&R 10+
Posted: Wed Dec 03, 2003 5:21 pm
by Quail
We are having a problem with parameter length. We set up the parameter initially to have a maximum of 10 characters. The box is checked to update the parameter every time data is input. From time to time we get the error: Fatal Error. Save your report, and exit the program (9)____I can go into the parameter screen and edit the format. I don^t have to change the value just open the format screen and close it then save the report and it works fine.____Any idea why this problem is happening and is there a fix or patch that will correct it?____Thanks!____Quail
=> RE: R&R 10+
Posted: Wed Dec 03, 2003 10:00 pm
by kfleming
Was the parameteRR field created in 10+?__I know that that problem had been seen in earlier versions.____Kathleen__R&R Support
==> RE: R&R 10+
Posted: Thu Dec 04, 2003 6:05 pm
by Quail
The parameter field was most likely created in 10, not 10+. If I delete the field and recreate it will this fix the problem?____Quail
===> RE: R&R 10+
Posted: Fri Dec 05, 2003 8:04 am
by kfleming
It should.____Kathleen__R&R Support
====> RE: R&R 10+ Fatal Error (9)
Posted: Wed Jan 21, 2004 1:55 pm
by Quail
[updated:LAST EDITED ON Jan-21-04 AT 02:00 PM (EST)]I am still getting that error on some reports where I have deleted an recreated the parameters. Do you have any other suggestions?____Quail
=====> RE: R&R 10+ Fatal Error (9)
Posted: Wed Jan 21, 2004 5:12 pm
by kfleming
If they are created in 10+ they should not give this error.__If you want you can send me your report/data files and I will have a look.____Kathleen__R&R Support__kfleming@livewarepub.com