Page 1 of 1
RR8 Won^t Eject Single Page Reports
Posted: Tue Jan 21, 2003 12:09 pm
by dknapp
I have several reports, each just one page long, that will print but not cause a page to eject from the printer. Other reports work fine. What I want to force is a page eject after the report is done. I tried added a page break line at the end of the report, but neither page ejected. The printer "has unprinted data" light goes on, but nothing gets ejected. When I pressed the eject page button, I got my report plus a blank page, caused I guess by the page break line. This happens on various models of HP laserjets (2100N, 2200N, etc.). Anyone got any suggestions?
=> RR8 Won^t Eject Single Page Reports
Posted: Tue Jan 21, 2003 1:13 pm
by kfleming
Have you tried using a different printer driver?______Kathleen__R&R Support
==> RR8 Won^t Eject Single Page Reports
Posted: Tue Jan 21, 2003 2:16 pm
by dknapp
On an actual HPIII printer we get the page ejects as we desire. However, most printers installed here are HP 2100TN or HP 2200TN printers, not obsolete old dogs. Since we use a standard desktop configuration that I have no input into, I really cannot go around to my users and reconfigure their default printer to use some other printer driver. If their PC gets replaced, I would have to trail around to reset the drivers. So, I guess the answer is that I have seen it work OK on one PC with an obsolete printer, and have seen it work incorrectly on several PCs with with up-to-date printers. What would you do in this case?
=> RR8 Won^t Eject Single Page Reports
Posted: Tue Jan 21, 2003 2:37 pm
by Thomas_Freitas_(Guest)
I am using R&R Version 8.1 Build 8.1.027 with a LaserJect III and I have no problems at all with putting in a new page line. I realize that this does not help your problem, but I wanted you to know that I have created a lot of various types of reports. All use New Page and work as they should. I do assume that you are checking on the new page box.