Liveware Publishing Support Forum

Hello,____In R&R you select the master table and the index, then you use the starting scope and ending scope to specify where to start the lookup and where to end the lookup. This works perfect in R&R. I added this report to and Rapid Runner Set and used the scope area to override the value in the original report, and the report takes too long to run. It seems like it is not using the index. __I have Rapid Runner v.1.2 and R & R v. 9. ____Any idea what I can do?____Thanks!__

Is the report returning the correct records? Is there also a query in the report?__You could try adding LOSCOPE() and HISCOPE() calc fields to the report layout to see what values are returned within the designer and again when the report is run from rapid runner.____Kathleen__R&R Support