Page 1 of 1
Report only prints first two pages
Posted: Wed Jan 17, 2007 9:55 am
by mdbentote
I am developing a report but, with two different input files it only prints and previews the first two pages. What is likely to cause this?
=> RE: Report prints first two pages
Posted: Wed Jan 17, 2007 12:39 pm
by TIM
Silly point but always best to try the obvious first :-) go file print and have a look at the print range and make sure that All is selected rather than page 1 to 2.____You have probably done this but if not :-)
==> RE: Report prints first two pages
Posted: Wed Jan 17, 2007 12:54 pm
by mdbentote
>Silly point but always best to try the obvious first :-) go __>file print and have a look at the print range and make sure __>that All is selected rather than page 1 to 2. __>__>You have probably done this but if not :-) __
===> RE: Report prints first two pages
Posted: Wed Jan 17, 2007 12:55 pm
by mdbentote
>>Silly point but always best to try the obvious first :-) go __>>file print and have a look at the print range and make sure __>>that All is selected rather than page 1 to 2. __>>__>>You have probably done this but if not :-) ______Thanks. I been testing a large file and set to print two pages. Whoops!!!:-)