Liveware Publishing Support Forum

While working on reports in R&R v9.0 every once in a while I get an Rsw error that says: "This program has performed an illegal operation and will be shut down. If the problem persists, contact the program vendor." Clicking [OK] shuts down R&R.____In case you need it, here is the error detail:__RSW caused an invalid page fault in__module RSW.EXE at 015f:00529ff1.__Registers:__EAX=00000000 CS=015f EIP=00529ff1 EFLGS=00010246__EBX=00000001 SS=0167 ESP=007ff368 EBP=007ff39c__ECX=00000090 DS=0167 ESI=00586628 FS=1157__EDX=007ff3b4 ES=0167 EDI=00921ca0 GS=0000__Bytes at CS:EIP:__8b 50 4e 83 e2 08 85 d2 75 33 8b 4d dc e8 c7 2e __Stack dump:__007ff398 007ff378 00000000 00822084 00822084 00000001 006db73c 007ff3a8 5f40227f 00822084 0081fe7c 00000005 00000000 007ff3b8 0052b1a1 007ff3b4

Are you using 9.0.009?__Does the error occur in the middle of designing a report?____Kathleen__R&R Support

I am using Build 9.0.007

Start by downloading the 9.0.009 update and see if that helps.____Kathleen__R&R Support