Page 1 of 1
Small fonts on R&R Reports
Posted: Mon Apr 23, 2001 4:19 pm
by Tom_Walden_(Guest)
Still using 8.0 (but hoping to upgrade to 9 soon), I^m building a calendar report, but I need to use a 6 point font for the text in each block. Is there a standard font available that I can use to get my 6 point size (haven^t found one myself yet)? Or is there a way to override the size or import (and ship) a separate smaller font with my reports? Or do I just need to get version 9 to get my smaller fonts?____Thanks again,__Tom
=> RE: Small fonts on R&R Reports
Posted: Mon Apr 23, 2001 4:47 pm
by Lonnie_Wright
If I understand your question, all you need to do is type in the desired font size. It will enter even though it is not on the pull down scale.
==> RE: Small fonts on R&R Reports
Posted: Mon Apr 23, 2001 5:01 pm
by Tom_Walden_(Guest)
I think I tried that already, but I will give it another go in case I did something wrong earlier.
===> RE: Small fonts on R&R Reports
Posted: Tue Apr 24, 2001 5:11 pm
by kfleming
Typing in the smaller point size should work.____Kathleen__R&R Tech Support
====> RE: Small fonts on R&R Reports
Posted: Tue Apr 24, 2001 7:07 pm
by Tom_Walden_(Guest)
>Typing in the smaller point size __>should work. __>__>Kathleen __>R&R Tech Support ____Maybe it does with versions later than 8.0, cause it sure doesn^t work in that version. If you would confirm that it does in fact work in 9.0, Kathleen, then that will be motivation enough for us to buy the upgrade now instead of later.____Tom______
=====> RE: Small fonts on R&R Reports
Posted: Wed Apr 25, 2001 10:16 am
by kfleming
I was just able to change to Arial 6 point in one of the R&R sample reports using V9. (But I have also been able to do that with earlier releases as well).____What you can also try is using Options Default settings and set your default point size to 6. That should then be used for any new fields that you place on the report.____Kathleen__R&R Support