Page 1 of 1
Step-Up Error Message
Posted: Wed May 21, 2003 9:45 am
by Robert_Seidman
I have now installed the Version 10 step-up.____When I try to create a new report using a Template, after selecting the Master file, I receive the following error message____"Access to an unnamed file was denied".____How can I correct this?____I thank you in advance for your prompt response.____Sincerely,__Bob
=> RE: Step-Up Error Message
Posted: Thu May 22, 2003 12:40 pm
by kfleming
Try turning off the Data Dictionary by adding the line Dictionary=0 in the Defaults section of RRW.INI.____Kathleen__R&R Support
==> RE: Step-Up Error Message
Posted: Thu May 22, 2003 3:27 pm
by Robert_Seidman
Dear Kathleen____Unfortunately, that does not have any effect. Any other ideas?____Thanks____RHS
===> RE: Step-Up Error Message
Posted: Fri May 23, 2003 1:29 pm
by kfleming
It still does sound like a dictionary error.__I will not be able to check into why until next Tuesday when I return from London though..____Kathleen__R&R Support
====> RE: Step-Up Error Message
Posted: Wed May 28, 2003 7:25 am
by kfleming
I just tried this and did not get the error on the XP machine where I just did a step up upgrade.__Apart from seeing this error, does the report work correctly?__Does the problem occur only with template based reports?______Kathleen__R&R Support