Liveware Publishing Support Forum

I have a report that cannot load blank.bmp. Based on a prior message, you said the location is the image or program directory. The program directory was g: rw. I did not have an image directory set and when I tried to set it, it did not save anything and it came back up blank.____The report is being run from a program running from the g:fc directory. When I loaded rrw from withing g: rw and tried to load the report definition contained in a different directory without the data files, it also complained about the blank.bmp file, but the report designer appeared to be pointing to c:program files rver10lank.bmp. That was where the designer was when the report was originally defined.____How do I get this changed in the report definition as I would like it to point the the current program directory (i.e. the directory from which rrwrun was called as in g: rw rwrun user 2.____I want to have a common network directory location, which is g: rw.____Thanks, Cliff.

You should be able to set the default image directory in your INI file (ImgDir=) and have R&R look for BLANK.BMP in that directory.____Kathleen__R&R Support

I did not have the ini file ini the runtime directory. Thus, it would not save it. It was reverting to the program directory of original program installation, not the run time directory. When I created ini file and added/edited the location, it then found blank.bmp in this location.____Thanks.