Page 1 of 1
multiscan report problems
Posted: Mon Sep 22, 2003 11:43 am
by cal
I have several multiscan reports to build. I^m having a little difficulty. First, when using the band properties to set the scanning table property, I^m not allowed to access the property "Scan table".____Why?____
=> RE: multiscan report problems
Posted: Mon Sep 22, 2003 1:22 pm
by kfleming
Your report must not have a multiple scan relationship.____This property is only available when a report contains relationship structure where a parent table has two directly scanned children. So that a field from A is used to link to scanned table B and a field from A is used to link to scanned table C.____Kathleen__R&R Support
==> RE: multiscan report problems
Posted: Mon Sep 22, 2003 1:46 pm
by cal
Thank you, Kathleen. I had just discovered that I had related A to B then B to C, rather than A to C.____It^s embarassing when one "goes suddenly stupid" after all these years!____Sheepish regards,__Cal