Page 1 of 1
parameteRR problem
Posted: Thu Jun 09, 2005 9:47 am
by Jeremy_Suiter_(Guest)
None of my parameteRR fields from the 4th onwards show when I run a report. Is this right?____I^m using xbase version 11.0.006____TIA____Jeremy
=> RE: parameteRR problem
Posted: Thu Jun 09, 2005 12:08 pm
by kfleming
The parameteRR value entry screen in that version only displays 4 at a time in the window but there is a scroll bar on the right to see the additional parameteRRs.____Kathleen__R&R Support
==> RE: parameteRR problem
Posted: Fri Jun 10, 2005 11:10 am
by Jeremy_Suiter_(Guest)
It^s not doing that at all. There^s no scroll bar to move down to show the others.____Jeremy
===> RE: parameteRR problem
Posted: Sun Jun 12, 2005 9:11 am
by kfleming
Are the others used in the report and set as prompt at runtime in their definition?____Kathleen__R&R Support
====> RE: parameteRR problem
Posted: Mon Jun 13, 2005 7:08 am
by Jeremy_Suiter_(Guest)
yes they all are
=====> RE: parameteRR problem
Posted: Mon Jun 13, 2005 7:11 am
by Jeremy_Suiter_(Guest)
I just found out the problem. If the field isn^t used in the report (which I hadn^t got around to) it doesn^t prompt for it.____Thanks____Jeremy