Page 1 of 1
Can^t find Blank.bmp
Posted: Thu Mar 18, 2010 9:25 pm
by ccoller
Installed 12.5.001 on a new Windows 7 system with 64 bit processor.____When I open the report "Production Page.rsw" it can^t find Blank.bmp. Then Windows closes R&R.____The report works fine on my Windows 2000 system.____Here is where Blank.bmp exists on the new system:____C:Program Files (x86)Liveware PublishingReportWorks Infinity\____I have other reports that run on the new system.____Any suggestions?__
=> RE: Can^t find Blank.bmp
Posted: Thu Mar 18, 2010 9:28 pm
by kfleming
What happens if you go to Options File Setting and point the image folder to the location of BLANK.BMP____Kathleen__R&R Support
==> RE: Can^t find Blank.bmp
Posted: Fri Mar 19, 2010 10:28 pm
by Clyde_Coller_(Guest)
What happens is that the problem goes away.____Thanks__
==> RE: Can^t find Blank.bmp
Posted: Wed Jun 02, 2010 8:56 pm
by DaSe
Do I have to install the file BLANK.BMP along with the Viewer Executable ?__If yes, must the file BLANK.BMP be in the same folder as the file RRW.EXE ?____Danny
===> RE: Can^t find Blank.bmp
Posted: Mon Jun 07, 2010 8:54 pm
by kfleming
You can put it in the program folder or in the default image folder that is specified in your INI file.____Kathleen__R&R Support