Label printer-Post from Archive

[kfleming]

Hello,__I have a problem with a label printer Zebra 3842. Every printout, I think the R&R writer route some printer commands to the printer. __In the windows printer setup the wide of the label is 10,5cm the height 6 cm. __When I print a R&R report (Version 12.5) I go to properties in the printer selection window. But here I see wide 12,4cm and height 29,4cm and the printer will not print properly. When I change the values at this point to 10,5 and 6cm, the printout is o.k.__What can I do?__Is it possible to create a report without printer commands?____Thanks__Wolfgang ____