RRWRUN Crashes When Relation Added

[marcel]

I have a report in R&R 8.1 which runs fine in Designer but when I try and run it from within my application RRWRUN crashes. If I remove the relation that is setup then the report runs fine in my application. Do you have any suggestions as to what might be causing this?____Thanks,____Marcel

[kfleming]

No particular known bug comes to mind.__Does the runtime error occur on the same machine where the designer runs successfully?____Kathleen__R&R Support

[marcel]

>No particular known bug comes to mind. __>Does the runtime error occur on the same machine where the __>designer runs successfully? __>__>Kathleen __>R&R Support ____Yes it does...____If I run the report using the runtime outside of my application it also works fine. I only get the errors if I try and run the report from within my application.

[kfleming]

Is that related table open in your application when you are trying to run the report?____Kathleen__R&R Support

[marcel]

>Is that related table open in your application when you are __>trying to run the report? __>__>Kathleen __>R&R Support ____Yes, the related table is usually open. I just tried running the report with the related table closed and RRWRUN still crashes.

[Mary_S._(Guest)]

I also have ver 8.1 and had the same problem when adding a 4th relation - 1 to 3 relations, fine, add the 4th, crash. Sorry to tell you this but the problem went away when we upgraded from Win98 to Win2000 and also upgraded hardware (more memory). Not sure which was the fix but either way it^s not a very cost-friendly solution. Hopefully you^ll find another way.....

[kfleming]

But wasn^t your crash occuring in the designer at the point of adding the additional relation?____This problem is a runtime crash and only within his application.____Kathleen__R&R Support

[Mary_S._(Guest)]

Yes, your right. Good luck!