parameteRR problem

Jeremy_Suiter_(Guest) · Post by **Jeremy_Suiter_(Guest)** » Thu Jun 09, 2005 9:47 am

None of my parameteRR fields from the 4th onwards show when I run a report. Is this right?____I^m using xbase version 11.0.006____TIA____Jeremy

kfleming · Post by **kfleming** » Thu Jun 09, 2005 12:08 pm

The parameteRR value entry screen in that version only displays 4 at a time in the window but there is a scroll bar on the right to see the additional parameteRRs.____Kathleen__R&R Support

Jeremy_Suiter_(Guest) · Post by **Jeremy_Suiter_(Guest)** » Fri Jun 10, 2005 11:10 am

It^s not doing that at all. There^s no scroll bar to move down to show the others.____Jeremy

kfleming · Post by **kfleming** » Sun Jun 12, 2005 9:11 am

Are the others used in the report and set as prompt at runtime in their definition?____Kathleen__R&R Support

Jeremy_Suiter_(Guest) · Post by **Jeremy_Suiter_(Guest)** » Mon Jun 13, 2005 7:08 am

yes they all are

Jeremy_Suiter_(Guest) · Post by **Jeremy_Suiter_(Guest)** » Mon Jun 13, 2005 7:11 am

I just found out the problem. If the field isn^t used in the report (which I hadn^t got around to) it doesn^t prompt for it.____Thanks____Jeremy

Liveware Publishing Support Forum

parameteRR problem

parameteRR problem

=> RE: parameteRR problem

==> RE: parameteRR problem

===> RE: parameteRR problem

====> RE: parameteRR problem

=====> RE: parameteRR problem